15 pcs Slide Hammer and Puller Set NORDBERG NT701006C

Slide hammer with 570mm shaft. Use eight ways: external three-jaw puller, internal three-jaw puller, external two-jaw puller, internal two-jaw puller, grip wrench adaptor, lip puller, hub puller, dent puller. Supplied in carry-case.

A reverse hammer is a hand tool designed to create a retracting force. A hand tool used to repair the body of a car by creating a retracting force. Unlike a conventional hammer, it does not affect the surface by deforming it as it is driven in, but instead pulls the metal towards itself. It is used for dismantling bearings, pulleys, gears and other parts by hammering with the application of back-impact load. Finds application at car service stations (STO), car service stations, workshops and industry.

• The tools of the set are made of durable structural steel. Oxidized and zinc coating provide protection against corrosion and high resistance to wear.
• The tools are supplied in a plastic case for convenient storage and transportation.
• Puller Type: Twin Leg
• Internal Capacity: Ø35-110mm
• Reach: 82mm
• External Capacity: Ø50-140mm
• Reach: 75mm

Device and principle of operation

• To carry out a neat straightening of a dent it is necessary to fix the pin of the tool at its beginning. It is inadmissible to immediately fix for the center of the defect, since when pulling away, the metal will doubt, and sharp corners will be obtained. Often, when using a hammer on dents without sharp bends, it is possible to level the surface so much that the former defect will be completely invisible. No putty or paint will be needed. On significant defects, work slowly and smoothly.